.30vg(P) Abl 21e Slide Carburetor
This part is discontinued and we no longer carry it.
Description
This is the O. S. Max 30VG(P) Rear Exhaust Monster Truck Engine
with Pilot Type Crankshaft.
Advanced Bi-Metallic Liner (ABL) cylinder liner construction
This process uses a double layer of plating material rather than
one thick layer. This helps the metal bond to the cylinder and is
more durable. Also, the plating process is more consistent,
resulting in a more precise fit between piston and sleeve for
better compression and longer life.
Machined aluminum piston, 3-port cylinder liner and double bushed
knife edge connecting rod
21E single needle Slide Valve Carburetor (OSMG2449) with insulated
sleeve to prevent fuel vaporization
SG (pilot) type oversized crankshaft with rubber-sealed front bearing
and oversized rear bearing to handle high torque loads
Two year limited warranty
Manual, #8 Glow Plug, #203 Air Filter, Two Foam Filters and two
air filter O-rings
nitro content recommended as starting point
Most of the fuels we carry meet or exceed the lubricant content
required for optimum performance and maximum engine life. In the
past, the conventional lubricant content used in fuel was 18%. But
with new advanced technologies, fuels like Red Alert and O'Donnell
for example, have a better quality of lubricants even though the
percentages of lubricant content are lower. These high-tech
lubricants provide exceptional cooling and protection.
Bore: 0.728" (18.5mm)
Stroke: 0.717" (18.2mm)
Practical RPM: 4, 000-36, 000
Power Output: 3.0 ps/28, 000 RPM
Weight: 12.7oz (360g)
Crankshaft Size: 1/4-28
Factory Needle Valve Setting: 2-3/4 turns OPEN from fully closed
Mixture Control Valve Setting: Needle head flush with the side of
ball link housing then back in 1-1/2 turn
Distance Between Mounting Holes Same Side: 0.83" (21mm)
Distance Between Mounting Holes Opposite Side: 1.4" (37mm)
Distance Between Mounting Holes Diagonal: 2.3" (59mm)
Height Bottom of Mounting Ears to Top of Cylinder Head: 3.8" (97.7mm)
Width of Mounting Ears: 1.8" (45mm)
Width of Crankcase Below Mounting Ears: 1.2" (30.8mm)
Distance from Front Bearing to End of Crankshaft: 1.2" (29.5mm)
Distance from Center of Engine to Front Bearing: 1.7" (44mm)
Distance from Center of Engine to Backplate: 0.85" (21.6mm)
Needle Settings: High Speed: 2 3/4 turns out from fully closed
Metering Needle (low speed): flush with ball link
body, then 1.5 turns in
Throttle Stop Screw: 1/2mm open from fully closed
Manufacturer information
All warranties and guarantees, including missing items, are handled directly by the manufacturer of that item. Should there be any problem with a product, you (The Customer) will need to contact the manufacturer to obtain service. Manufacturer contact information is available upon request. We must be contacted for a return authorization number before returning items for any reason. We cannot accept returned items that have been opened or are not in their original sealed factory containers.
Compatible vehicles
Alternate part numbers
Here are some alternate part numbers and product codes that you may find this part listed under on other sites:
Related parts
Additional details
Shipping weight
20.64 ounces
585.17 grams
1.29 pounds
Package dimensions
4.13 x 6.13 x 7.75
⚠️ WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov ⚠️