Product Features
*Continuously powers up to 3 LEDs
*Power Source + LED Controller combo Overview The central point of every LED lighting system is the LED controller. It is this component that is going to appropriately power the LEDs so they do not get too much power and blow. It also separates the LEDs into independently controllable groups to which specific functionality can be assigned. It is the brain that tells the LEDs how and when to light. Directly power up to 3 LEDs. Current limiting resistors are built right in. Using the RX Direct2LED, LEDs can be directly powered from any available channel on the RX (receiver). If no channels are available use a Y-harness or RX Pass-Thru. Used with electronic switches, LEDs can be run at dual-intensities or switched on/off from the TX (transmitter).

SPECIFICATIONS:

YP OUTPUT CURRENT (per LED channel): 20-30mA Controller pins can be directly soldered to for DIY projects. Use heat shrink to insulate each pin.
*Lights are designed to be used in extreme nighttime and low visibility running environments and are very high output.
*DO NOT look directly into beam.