This is the glow powered, radio controlled, 1/8 scale
Mugen MBX7 Off Road Buggy Kit.
Chassis: A7075 hard anodized aluminum 0.12" (3mm) thick
Receiver Box: Molded composite construction, relocated for better CG
Drive: Four wheel three differential shaft drive
Shocks: Four 15mm oil filled hard anodized aluminum body, shortened
front shock bodies with redesigned front and rear boots
Front Shock Tower: 0.20" (5mm) A7075 aluminum with optimized geometry
Rear Shock Tower: 0.16" (4mm) thick A7075 aluminum
Gearbox: Sealed, front and rear
Differentials: Planetary geared
Fuel Tank: 4oz (120cc) approximate
Transmission: Single-speed
Ball Bearings: Full set
Suspension: 5mm A7075 aluminum mounts with redesigned upper and
lower front and rear suspension arms and uprights
Body: Clear buggy type with white molded plastic high downforce wing
with slider system for more or less downforce
Brake: Dual disc with new brake cam and new front and rear linkage
Clutch: 3-shoe, E0710 heavy duty aluminum clutch shoes
Clutch Bell: 13 tooth steel
Spur Gear: 46 tooth
Caster: Adjustable, caster/toe-in refers to the angle of the front
suspension when viewed from the side of the car in relation to the
chassis
Camber: Adjustable, camber refers to the angle of the tops of the
tires from vertical when viewed from front or behind vehicle
Steering: Bell-crank type, with carbon graphite steering brace and
adjustable Ackerman. Ackerman describes the effect of the inside
front wheel turning faster than the outside front wheel during
turns
Mugen MBX7 Off Road Buggy Kit with clear buggy body, white plastic
rear wing, decal sheet, window mask sheet, air filter, illustrated
instruction manual, silicone shock oil and diff oil
Engine: .21 cu in rear exhaust
Exhaust: Tuned pipe with manifold
Radio: 2-channel with standard servo for throttle and high torque
servo for steering
Starter Box: For 1/8 scale buggy use
Fuel, glow starter, building and track equipment
Vehicle
width: 12.2" (309mm)
Wheelbase: 12.4 - 12.6" (315 - 320mm) adjustable
Gear Ratio: 11.98:1
Weight: 7.4lb (3, 370g)
Body-
length: 13" (330mm)
width: 7.9" (200mm)
height: 3.7" (94mm)
For replacement Ball Bearings use:
Qty. Size Location Qty. Bearing Set
6 8x16mm Fr/R/Center Diffs 3 DTXC1585
4 8x16mm Fr/R Gear Cases 2 DTXC1585
2 8x16mm Front Hubs 1 DTXC1585
2 15x21mm Front Hubs 1 DTXC1601
2 8x16mm Rear Hubs 1 DTXC1585
2 15x21mm Rear Hubs 1 DTXC1601
4 6x10mm Steering 1 DTXC1561
2 5x10mm Clutch Bell 1 DTXC1535
jxs 01/02/13
ir/jxs
&