This is the 1/10 scale, radio controlled, electric powered,
ready to run XB Neo Racing Fighter Buggy.
For ages 14 and above.
Chassis: DT-03 plastic monocoque
Drive: Rear wheel with dogbones
Radio System: Tamiya Finespec 2.4GHz pistol grip with steering and
throttle trim and reverse and steering servo
Electronic Speed Control: Tamiya TEU-105BK with reverse (TAMC5055)
Motor: 540 brushed, preinstalled to assembled gearbox
Suspension: Fully independent wheel double wishbone
Differential: Bevel gear
Body; Painted polycarbonate
Driver Figure: Painted plastic
Shocks: Coil over plastic body friction, not oil-filled
Wheels: Black plastic
Tires: Front, grooved
Rear, pin spike
Steering: Direct servo with tie rods
Front Bumper: Spring type to absorb minor impacts
Camber: Non-adjustable, camber refers to the angle of the tops of the
tires from vertical when viewed from front or behind vehicle
Steering Tie Rods: Adjustable, caster/toe-in refers to the
angle of the front suspension when viewed from the side of the car
in relation to the chassis
RTR Tamiya Neo Fighter Buggy with brushed motor, ESC, painted body,
Rear Wing, 17T pinion gear, tires, wheels, shocks, decal sheet,
2.4GHz Radio and instruction manual
Battery: 7.2V stick pack with standard connector
Battery Charger: To match selected battery
AA batteries: Four for transmitter
Track and Maintenance equipment
Vehicle-
length: 15.5" (394mm)
width: 9.5" (241mm)
height: 4.8" (122mm) measured at rear wing
Wheelbase: 11.3" (288mm)
Front Tread: 8.7" (221mm)
Rear Tread: 8.2"(208mm) distance between centers of tires measured
side-to-side
Body-
length: 11.25" (286mm)
width: 5" (127mm) at widest point
height: 2.8" (71mm)
To Upgrade to Ball Bearings use:
Qty. Size Location Qty. Bearing Set
2 5x11mm Rear Uprights 1 DTXC1547
4 5x11mm Front Uprights 2 DTXC1547
8 5x11mm Front Uprights 4 DTXC1547
jxs 05/17/16
ir/jxs